QMARK CONVECTION HEATERS

-Ideal for elegant, supplemental comfort under windows for heat loss and condensation prevention -Unique two-piece extruded aluminum “Snap-Lock” closure design secures the one-piece top and front grilles to the one-piece back and bottom providing a rapid, secure fit all along the length of the unit -Front/bottom inlet air grille utilizes slots which create an attractive installation where inlet grille is visible-Unit comes standard with rear knockouts and unpainted back. Optional custom-painted backs and rear knockout options are available -Units can be mounted on floor, wall, or pedestals -Customize space with wall-to-wall installation, or as discrete units in standard lengths of 2-10 ft. -Units are available in a wide range of heating capacities per foot length (see specification charts) -Inside and outside corners can be ordered factory-cut and mitered to fit difficult or unusual spaces -Architectural-style end sections give a finished look when used as a stand-alone or where a wall-to-wall run is not desired -Full line of trim accessories, including matching blank sections, end caps, filler sections, inside and outside corners, diagonal end sections, and splice plates -Optional built-in controls include: line-voltage thermostat; twostage thermostat; on/off switch; transformer relay; power relay and pneumatic/switch -Right -or left-hand entry and built-in wire way (equivalent to 1/2 in. conduit) with factory-installed wiring -Easy connection of supply wiring from bottom, rear or end, as well as multiple wiring of adjacent heaters from one entry point -Thermal limit switch with linear type (full length) sensing bulb provides constant protection against overheating from any cause-Discharge air openings in top grille are punched slots which are pencilproof for safety